State Question

[Ron]

It seems like you have found a bug!

It can be solved ( temporarily ) by using commands that 'goto' the multi commands.
Set the state in the commands. In the mean time i'll see if i can find this little problem.

[Ron]

I've updated Girder and released 3.0.25pre3. Get it while it is hot !

[HughMuir]

Do states work differently on single commands than on Multi-Groups.
I have two commands Pause Play both set to the same event

Play
State count 2
Begin state 1
command Play

Pause
State count 2
Begin state 1
execute on all states except 1
command Pause

Works fine BUT.

When I do the same thing on two Multi-Groups (Full Screen/Normal Screen) both groups execute every time.


It seems that it would be cleaner if I could get the Multi-Groups to act the same as single commands.

[HughMuir]

The Multi-Groups seen work sometimes. but it not consistent. Have tried antirepeat wait time (100) no help.
Any thoughts. This problem shows up with Polyview (image browser/editor) and Realplayer Plus

[HughMuir]

Thanks Ron,
It over the years seems I have always been good at finding bugs. It was a good thing when I was in software development.

The Temp sounds good. I had a work around but it used 4 commands to enable and disable the groups. Yours of course is better. Funny, I was just researching the GoTo command today.