PDA

View Full Version : Girder Interference



dlp710
April 6th, 2005, 03:19 PM
I am using Girder 3.3.1c and an Evation IRMAN plugin on COM1. Girder is receiving IR codes at random, they are being displayed in the Girder toolbar, and I have no idea where they are coming from. Is it possible that a Wireless network can causing this issue? My previous plugin, IGOR, did NOT have this issue in the same environment...but I switched to IRMAN since it is rumored to be a better receiver, less overhead, etc.

When I do send a valid IR signal, Girder appears to pick it up, followed shortly by IR interference, so learning commands is next to impossible.

Anyone else experience a similar issue and ifso, how did you resolve?

Thanks

Rob H
April 6th, 2005, 03:46 PM
Does this happen at all times of day? If only in the daytime then sunlight is a possible cause.

Do you have a plasma display? That's often a culprit

The IRMAN may just be more sensitive than the IGOR.

dlp710
April 6th, 2005, 08:22 PM
Believe it or not, at least it was a surprise to me, when I turned off my laptop the mysterious IR signals disappeared. I believe it was the wireless NIC card in my laptop that was sending the signals. They are now gone.

Irman is definately more sensitive than IGOR.

Thanks for your help!

Ron
April 7th, 2005, 01:05 AM
I am guessing it was the IrDA port of your laptop that was setting of the irman.