New Multigroup state bug

[Ron]

I'll check it out.

[Ron]

Okay fixed in Girder 3.0.25pre5

[Ron]

Nope, very much a missing feature :grin:

[HughMuir]

Ron
When using states to toggle two multigroups Girder does not seem to be saving the state information with the file.

eg:
I have a file with:
Multi group 1
State Count 2
Begin State 1
Execute on all states except 1 Not Checked

Multi group 2
State Count 2
Begin State 1
Execute on all states except 1 Checked

Then I save the the file and reopen it.
The Multigroups are then:
Multi group 1
State Count 1
Begin State 1
Execute on all states except 1 Not Checked

Multi group 2
State Count 1
Begin State 1
Execute on all states except 1 Not Checked

Both Mutigroup 1 and 2 are set to trigger on the same receive code. This problem does show up on single commands.

[HughMuir]

Thank again Ron for your quick response..
At least this confirms that I wasn't going crazy.

Hugh