bjoern
October 13th, 2002, 01:55 PM
Hi,
i have two problems with the initialization of my UIRT (Girder 3.0.25, Ruuds schematic, Jons firmware/driver v. 1.6) which i didn't encounter before:
1. I get errors on enabling the device (could't read...), need to repeat about 2-4 times before it works. From there, no problems at all (all codes come in fine, no noise or erratic behaviour whatsoever), so i come to think that it can't really be an eletrical problem (also doesn't help to skip init check). Any hints to what might be my problem?
2. When the system wakes up from APM/ACPI suspend, the UIRT doesn't work until re-enabled (the game of 1. starts over). Is there a possibility to reset and enable the input devices on wakeup?
Thanks for help...
Bjoern
i have two problems with the initialization of my UIRT (Girder 3.0.25, Ruuds schematic, Jons firmware/driver v. 1.6) which i didn't encounter before:
1. I get errors on enabling the device (could't read...), need to repeat about 2-4 times before it works. From there, no problems at all (all codes come in fine, no noise or erratic behaviour whatsoever), so i come to think that it can't really be an eletrical problem (also doesn't help to skip init check). Any hints to what might be my problem?
2. When the system wakes up from APM/ACPI suspend, the UIRT doesn't work until re-enabled (the game of 1. starts over). Is there a possibility to reset and enable the input devices on wakeup?
Thanks for help...
Bjoern