GC port and repeat

[reefer]

Sorry if this subject was already discussed.
Just figure the reason why I couldn't get repeat for vol-up out.
If I set GC port No. in Action in ND, I can't get repeat IR signal for IR command that is together with GC port command in action.
Is there any easy solution for this?
Thanks.

[Ben S]

Which version of NetRemote is this, and are you using the NRBasic command to set a variable, or executing lua to set the variable?

Using the NRBasic set variable action is a 0 cost operation and will allow for repeats. Any other method of setting the IR port will not allow for repeats.

Also, a button alias is not a 0 cost operation, so if you are using an alias to set the value of the IR port, this is also not supported for repeats.

[reefer]

Thanks for reply.
I'm using NR 1.1.0.42 with MB 1.0. and Netremote designer.
I simply put Raw IR codes and defined port No. in Action designer list in Netremote Design. Buttons without GC port No. can do repeats w/o problem but buttons with GC port No. can't.

[Ben S]

Ah. Now I understand. This will be fixed in the next release.

[reefer]

8) 8)