Need Igor SFH 56 DEvice driver update for Gilder 3.10

[Ron]

Its GIRDER, with an R, look at the big picture at the top of the page :smile:

The old Igor plug should work, just enable compatibility mode.

[giova]

Hi, i have a big probleme, i'm currently trying to update my gilder (3.0.23) to 3.10beta16, and not any given IR driver works.

I only suceed to use my remote control with :

Igor SFH 56 Device driver

Here how i've configured it to works :
Port: Com 1
Mode: DCD

Is theyr a way to use an other compatible driver (how to configure it please, i ve made many test that didn't works with Gilder 3.1 given drivers)?

Will Igor SFH 56 DEvice driver be updated?

MAyday, my gilder doesn't works anymore !!!!!
(well is going to doesnt work anymore because of this driver compatibility problem)

thanks by advance

[giova]

Yes it works, but software says that old pluggins will not work anymore in futur versions, and that is the only driver that make my remote working for the moment.

i was just wondering about it, because if i can't use my remote.... :smile:

[giova]

Thank you very much, i ve tested the new igor pluggin V1.0 for girder 3.1, with 3.1b17 version, and it works fine.

I've just had to put priotity to 8 (the maximum) else if it was less, my IR receiver used to don't work all the time.

thank u again.

best regards

[giova]

Finally, i got few problem with this new driver, see this thread to know more:

http://www.girder.nl/phpBB/viewtopic.php?topic=1368&forum=3

[abc123]

hello,
I have a big problem with girder ,when the igor sfh-56 drivers is enable,the girder is not responses .when the igor sfh-56 drivers is disable,and the keybloard is enable,it works fine.could you tell me how about your girder?

please reply me with E_mail: l_xianhao@163.net.
Thak u very much!