eventstrings keep getting executed twice in a row with remot

[Ron]

Send me an example with only the relevant commans in it.

[worldrave]

Hey RonB,
When I am using say a Multigroup with states and including a Say command or even using 1 Multigroup with 2 commands that sends a ctrl-f1 one press and ctrl-f2 another, it always seems to receive it twice (or should i say when i push button one, it acts like i hit it twice and flips through 2 groups instead of 1 even with antirepeat on like 1000ms it still does it)

And when i learn it to a keyboard button, it works fine. I reset states and all, and it still does it, i hit the remote button once and quick cover the ir with my finger and girder still executes it again immediately after.

I also went into the IrMAN setting and adjusted all the way to SLOW and tried on FAST and it still does it.

Even a simple multigroup that controls switching between two Groups (on and off) still, when using remote button, the evenstring command gets done twice.

I asked you before recently about events not working right with multigroup on my system and you told me to send you an example .grl file to check, well i've tracked down the problem and found I am doing the states right, it's just doing it twice for some reason. That's how i found where the problem was when i (just happen to) re-learn to a keyboard and it was doing everything fine, then relearned back to a remote button, and BAM!!, it was going back to getting executed twice in a row real fast when only pressing one (and with antirepeat set up to 1000) still does it.

Any help on this (hopefully)
I'm using IrMAN BTW. on WinXP Home also.