domloff
February 15th, 2006, 12:22 AM
Hi
I'm trying to get this switcher to work using the Serial plugin with Girder 3.3
Heres the manual that shows the commands used :
http://www.neothings.com/documents/Avalon%20User%20Guide-web.pdf
I can get it to work using Hyperterminal no problems. Even works if I load a file with the commands.
I've set the switch up as a new device with the stated settings in the manual.
When I attempt to do the same in Girder it says command sent at the bottom of Girder but nothing happens!
I must be doing something wrong or missing something very simple! :-?
Dom
I'm trying to get this switcher to work using the Serial plugin with Girder 3.3
Heres the manual that shows the commands used :
http://www.neothings.com/documents/Avalon%20User%20Guide-web.pdf
I can get it to work using Hyperterminal no problems. Even works if I load a file with the commands.
I've set the switch up as a new device with the stated settings in the manual.
When I attempt to do the same in Girder it says command sent at the bottom of Girder but nothing happens!
I must be doing something wrong or missing something very simple! :-?
Dom