Multiple X10s

[domloff]

Hi

Believe it or not I need to access 2 CM11 modules from the same girder.

I'm not sure how easy it is to do this?

The reason is that I have very isolated mains and I need one CM11 module to switch on/off a device on one mains ring and another CM11 module to switch on/off another device on another mains ring.

Is this possible?

Thanks

Dom

[Promixis]

No, but you could use another X10 PLC like the Powerlinc.

[domloff]

The trouble is that I've got 2 CM11s (was using one of them elsewhere).

Is there no easy way to write a serial driver for it, so that I can assign it just as another serial device? I only need it to send a ON and OFF signal.

Thanks

Dom