Insteon Device Manager showing incorrect X10 addresses

[grog]

I have X10 addresses assigned to most of my Insteon switches but I noticed that in the Insteon Device Manager the addresses are incorrect. In some cases they will have the house code and a question mark for the device code (e.g. E?). The house code is actually correct but it isn't reading the device code for some reason. In other cases it is showing both a house code and a device code but the device code is incorrect. e.g. I have one switch that shows the address as E15 but the real address is E7. I have another one that shows the address as E8 but the real address is E13.

It's not really that big of a deal since I keep a spreadsheet with all of my switches and addresses but it would be nice to have the correct info in Girder too. Any idea why it's not reading the address properly?

Thanks

[Promixis]

will look into it but in the mean time, would hit the update button and see if it reads it correctly.

[grog]

I tried the update button on a few of them but it made no difference.