It works :P - Was: Grrr almost ready :(

[Luc]

Nice work,

what problem do you have with the programming?

[Luc]

There are a few possibilities:
What are you using as programming voltage? If it's on the low side you can get this error.
Try reducing the programming speed if you have a real fast PC.

Luc.

[Xanthorax]

My UIRT2B pcb was almost done. Today i abused some machines that wern't used at the time to make a small panel with 8 uirt2b pcb's. I used the gerber files that Luc send me to make a film and cnc files.

After plotting the film, the raw panel was drilled on a cnc machine.
After cleaning (pre etching) and laminating the panel with fotoresist the panel was exposed with the film. Then the resist was fixed after wich the non exposed resist was removed. Then the panel was etched.
After this the left over resist was removed and the panel was cleaned.
The the panel went thru a fluxing machine after wich it was readu to enter the hot air leveler (adding lead/tin to the copper).
Then once more the panel was cleaned.
I was now ready for the last step, milling the pcb's out of the panel. But at that time all the cnc machines where used.
So know i have to wait till monday :(.

[Xanthorax]

Whoo pcb's are done

http://xanthorax.student.utwente.nl/images/uirt2b-1.jpg (http://xanthorax.student.utwente.nl/images/DCP03041.JPG)

http://xanthorax.student.utwente.nl/images/uirt2b-2.JPG (http://xanthorax.student.utwente.nl/images/DCP03038.JPG)http://xanthorax.student.utwente.nl/images/uirt2b-3.jpg (http://xanthorax.student.utwente.nl/images/DCP03039.JPG)

Now i think i fried my pic couse i can't programm it :(

[Xanthorax]

Well the programmer stops after say 10 seconds, with an error programming at 0x00?? where ?? is a random number. The next time i try it it stops at the beginning.

[Xanthorax]

I bought a new pic today (4Mhz one) and it's running just fine now :P