oe1k
October 13th, 2002, 03:55 PM
I saw that this was mentioned in some of the betas, but figured a new topic was needed.
I'm using Win98SE, and Girder 3.20 (release) shows an empty icon in the system tray if it is run on startup. Only way to get an icon to display in that spot is to "Exit" Girder (the program still works, just an empty icon) and re-start it. If I manually run it, the systray loads a blank icon and then the litte "remote" icon shows up about the same time that the Girder splashscreen goes away.
I had this same behavior with some of the 3.2 betas aswell. 3.2 beta 19 seemed to not have this problem, for me (could just be luck).
I'll go get 3.20a and report back (but I don't think anything in 3.20a's changes would address this).
-Richard
I'm using Win98SE, and Girder 3.20 (release) shows an empty icon in the system tray if it is run on startup. Only way to get an icon to display in that spot is to "Exit" Girder (the program still works, just an empty icon) and re-start it. If I manually run it, the systray loads a blank icon and then the litte "remote" icon shows up about the same time that the Girder splashscreen goes away.
I had this same behavior with some of the 3.2 betas aswell. 3.2 beta 19 seemed to not have this problem, for me (could just be luck).
I'll go get 3.20a and report back (but I don't think anything in 3.20a's changes would address this).
-Richard