dumb question? 3.0 user

[vynce]

There is a drop-down box next to the learn button. Change that from Girder Event to All, then it will work the same way as Girder 3.0 for learning remote events. The Girder Event option is useful for other non-IR related events. You can make commands execute on Girder open/close, etc. as well as create custom events for command-line use.

[Riff2]

I have used girder 3.0 for a while now, and just decided to upgrade to the latest version 3.2. I use an IRMAN and Pronto setup. The way I used to learn events was by pressing the learn event button and then pressing the corresponding button on my Pronto. Now when I press learn event, another menu pops up asking me to type commandline eventstring or select from a menu of options. I tried pressing my remote button at that point hoping it would fill in the IR code, but it does not. I'm sure getting the IR code into Girder is really not that hard, but I can't figure out how to get girder 3.2 to learn my remote IR codes for the life of me. I've read through the FAQ and tried searching the messageboard, but haven't found a solution. Any help is appreciated. Thanks