Report Code CCB-F

[egon1st]

Hi

I downloaded girder 5 yesterday from this website and installed it and everything was fine.
But today it wont start up again. I instantly get an errormessage and the program closes.

The error message is following:
"Your system clock appears to have been set back, possibly in an attempt to defeat the security system in this program. Please correct your system clock before trying to run this program again. If your clock is correct, please contact the author of this program for instructions on correcting this error. (report code CCB-F)."

So, my system clock is not set back or anything.. but I adjust my system clock after every windows boot manually.
I also tried to deinstall and install girder again.
Wont work, same error, no start up :/

[Ron]

You cannot use Girder and change your system clock all the time. Contact gsupport@promixis.com for a fix key to remedy the situation this time.

[Rob H]

but I adjust my system clock after every windows boot manually.

Um... may I ask why you adjust it manually?

[egon1st]

ah sorry I dont really adjust manually.

what I mean is that I use an application to synchronize it, I dont use the internal windows function of the clock for this.
I do this because of the more confortable options like synchronize intervalls and other things.

mh so I can use such an application and girder not at all? :(

[Ron]

You should be able to change the time a little but drastic changes will be picked up by Girder as an attempt to evade the trial period.

[Rob H]

That should normally be fine - I do the same here. However, I would normally only expect a clock synchronisation to update the clock by few seconds (or maybe minutes). The protection software that we use guards against the clock being adjusted by days - if it's detecting this in your case then there would appear to be a problem with the CMOS clock in your PC.