g4ce1
February 23rd, 2008, 02:23 PM
I have a simple application where I desire to controller two switchlinc dimmers with a power linc USB module and girder 5.0. I have MCEIR installed and working (I can capture IR commands from the remote in Girder). I can controller the dimmers using the USB Powerlinc Synapse program supplied with the Powerlinc USB module. I can't seem to figure out how to get the signals out to the switchlincs thru the Powerlinc USB in Girder 5.0. I think I need to add the powerlinc USB module to the "Device Manager" in Girder, but can't figure out how to do this.
I have added the powerlinc.dll to the plugins directory. But when I try to select it, it says "plugin was not loaded".
I re-installed Girder 5.0. Again, am capturing remote codes via MCEIR. Won't output signals via Powerlinc USB. Only difference is that now in the plugins section is says that the powerlinc USB plugin is loaded.
Thanks in advance for assistance.
G4CE1
I have added the powerlinc.dll to the plugins directory. But when I try to select it, it says "plugin was not loaded".
I re-installed Girder 5.0. Again, am capturing remote codes via MCEIR. Won't output signals via Powerlinc USB. Only difference is that now in the plugins section is says that the powerlinc USB plugin is loaded.
Thanks in advance for assistance.
G4CE1