Confused Newbie Requesting Help

[vynce]

Try putting all your image-opening commands in a multigroup and attach the eventstring to the multigroup. Then play with the state settings of each image opening command. There is help on states here: http://www.girder.nl/help/girderhelp/states.php.

[Jon391]

:-? My scenario is that when I press the (1) button on my remote an action will occur in Girder and it will load an image. So far that works, however I want to use that same button (1) to load another image after I press it a second time and a third, so on. The problem I have is that it loads the same image over and over again. Thankyou for taking the time to read, if you could help me out, that would be exellent!