WinDVR 2.0 problems

[vynce]

Check your cpu usage. If it is at or near 100% then these receiving problems are normal for the PB receiver. It decodes the signals in software instead of hardware which doesn't work well under high cpu load. If you need to receive IR under high load, you have to use a different hardware-based device such as the IRMan or UIRT.

[webbiscuit]

I'm having problems getting girder to recognize the proper IR command while WinDVR is open. Pressing the same button multiple always brings up a different IR code, which is never the correct code. As soon as I shut WinDVR down, everything works properly. I am running XP with a Packard Bell IR serial receiver (IGOR plug-in is installed). I'm using a geForce with Personal Cinema. Any ideas?

BTW - Any luck with the Divx FF/Rew controls?