how to restart pugin?

[Pablo1234]

I need information how to restart plugin. I think it is posible using gir_stop and gir_start bud i dont know how to do this.

Please Help me!

[josjojo]

Why do you need te know that?

[Ron]

Yes, I would be very interested in knowing that too.... are you creating a plugin or are you trying to load Girder plugins in your own program ?

[vynce]

I restart the UIRT2 plugin with disable device 31 then enable device 31. Works for me. I do this because when I disconnect the receiver from the UIRT2 and reconnect it on a longer cable it doesn't receive IR anymore. So I just restart the plugin and it works again.

[Pablo1234]

I'm creating my own plugin and I’ve already managed with this problem. I've just placed declaration of gir_* in the other file of the project and I've just used them. It works fine. About the plugin: this is plugin that uses serial port with IR receiver to retrieve information from RC. If you are inerested to place this plugin in to your project just give me a word.
This is Polish computer remote.

Pablo1234

[Ron]

If its finished feel free to send an email to me (you can find my address in the about box of girder ). Do you have an plugin ID ? If not you can use 58, let me know if you took it so I can reserve it for you.

[Pablo1234]

OK I'm still working on it, but in few days it is going to be finished. About id, this is hardware plugin so i think i should use 228 but if you like i can use #58.

Pawel1234

[Ron]

if you are developing for Girder 3.2 ( and you are) please use 58, unless you have a specific reason for using 228 you can always convince me about that ;-)