sraymond
December 1st, 2002, 10:03 PM
I'm playing with VolumeOSD - it's pretty slick! However, I was wondering how to go about getting a "press and hold" to repeat the volume up/down commands with an ATI Remote Wonder. I think the problem is complicated by the fact that ATI sends a different signal for the repeat, but I'm at a loss of how to go about this.
Also, is there anything documented about the working of VolumeOSD? I'm specifically interested in the difference between the command "set volume" and "volume change". The "set volume" seems to keep the item's slider in synch with the master volume. The "volume change" seems to do increase the item's volume when pressing the volume down (although at a larger step), although pressing volume up does increase. I'm not sure why the Wave had "volume change" - but it seems inconvenient. Having the wave volume maxed makes it hard to get a low volume out.
Thanks in advance for any guidance/info!
Scott Raymond-
Also, is there anything documented about the working of VolumeOSD? I'm specifically interested in the difference between the command "set volume" and "volume change". The "set volume" seems to keep the item's slider in synch with the master volume. The "volume change" seems to do increase the item's volume when pressing the volume down (although at a larger step), although pressing volume up does increase. I'm not sure why the Wave had "volume change" - but it seems inconvenient. Having the wave volume maxed makes it hard to get a low volume out.
Thanks in advance for any guidance/info!
Scott Raymond-