jeffelliott
December 21st, 2002, 01:16 PM
Hello all - I've been running Girder 3.1 for some time now because it still supports the Redrat2. Lately, I have purchased devices which I would like to control using the generic serial driver. When I try to install the generic serial driver with 3.1, girder reports errors. When I check the readme documentation that accompanies the serial driver, I find that you must have Girder 3.2 to use it.
Well, I can't update to 3.2 because I'll loose support for my VERY EXPENSIVE IR tranceiver. Is there a serial driver that will work with 3.1? If not, is Redrat now supported in 3.2? If not, what can I do if I need both redrat support and generic serial support from Girder? Thanks to all!
Jeff
Well, I can't update to 3.2 because I'll loose support for my VERY EXPENSIVE IR tranceiver. Is there a serial driver that will work with 3.1? If not, is Redrat now supported in 3.2? If not, what can I do if I need both redrat support and generic serial support from Girder? Thanks to all!
Jeff