[b]Delay for command[/b]

[jumper]

Hello everyone

I wondered if someone can tell me how to add a delay to any command in girder so that if the last command closes girder some commands wont be undone (One of the commands executes a program, next command hides the window of this program and the last command closes girder. But the commands have done so quickly that the program is not open yet when girder is already closed). Or is there any plugin for adding delay?
:wink: [/b]

[Mark F]

After the command that executes the application, use the Wait command (on the window tab). Check the box that says "Wait for window" and target the command at the application window. Be sure to put in the maximum wait time (in ms).