Allan_Khong
February 9th, 2003, 09:46 AM
:( I received my Uirt 2B 3 days ago, but having problem getting it to work.
Ever since I connected Uirt to the WOL pins, it will turn on by itself every time I shutdown window. I could only shutdown by pressing the power button on my PC. What is happening?
I really have no idea whether my Uirt is working. No matter how I tried to learn IR from my remote, there is virtually no response. This is how I did it: From girder, I add a command; highlight it and choose "plugins"; highlight "Uirt driver"; Choose "setting"; Choose "modify pic pot pin", and set GPIO to "port b2", "pulse" radio button, "pause girder until action/transmission is finished" radio button. Follow by "pic config" and program slot 1. When I try to learn, there is no response on the progress status bar no matter how I press my remote. Have I done correctly or my receiver had fried?
I don't know how to use the test program. But I noticed that when I set the COM port to 2 under girder, girder will load with no error message. However the test program will indicate at bottom, "unble to open port". The message disappear will I set it to COM1 instead of COM2 in Girder. What's is wrong here?
Plse help by pointing me to the right direction. Thanks in anticipation.
Allan
Ever since I connected Uirt to the WOL pins, it will turn on by itself every time I shutdown window. I could only shutdown by pressing the power button on my PC. What is happening?
I really have no idea whether my Uirt is working. No matter how I tried to learn IR from my remote, there is virtually no response. This is how I did it: From girder, I add a command; highlight it and choose "plugins"; highlight "Uirt driver"; Choose "setting"; Choose "modify pic pot pin", and set GPIO to "port b2", "pulse" radio button, "pause girder until action/transmission is finished" radio button. Follow by "pic config" and program slot 1. When I try to learn, there is no response on the progress status bar no matter how I press my remote. Have I done correctly or my receiver had fried?
I don't know how to use the test program. But I noticed that when I set the COM port to 2 under girder, girder will load with no error message. However the test program will indicate at bottom, "unble to open port". The message disappear will I set it to COM1 instead of COM2 in Girder. What's is wrong here?
Plse help by pointing me to the right direction. Thanks in anticipation.
Allan