OSD problem

[smintman]

hi, try this:
1. make multigroup - "Switch"
2. insert 6 commands into multigroup, 3 for each program
3. give names to commands - Powerdivx ON, Show Powerdivx, Powerdivx OFF, Winamp ON, Show Winamp, Winamp OFF
4.assign actions to commands - ON - enable group, ODD disable group, Show - OSD for 0,5sec
5. if you like menu style, you can write something like that " ***POWERDivX**** Winamp" and to second command " Powerdivx ***Winamp***", you will know what will follow, or you can roll down.
6. set command state for each command
Table
cmd statecount beginstate execute
1. PDIV on 2 2 N
2. Show PDIV 2 2 N
3. PDIV off 2 2 Y
4. WA on 2 1 N
5. Show WA 2 1 N
6. WA off 2 1 Y

7. you can make this for more groups 3, 4


Smintman

[ACClarke]

Je t'ai repondu sur le forum hardware.fr

[pirlone]

I'm interested in topic too (and don't know french :sad:( )
how to solve this thing?

pirlone

[Ninipc]

Hi all
I've some problems to do what I want with the OSD :eek:
ok I've two groups, winamp and powerdivx
I made a group switch, and now I want the OSD display the group who is enable.
example:
I press the button (I've only one button for switch between different groups), and the "powerdivx" group is enable.I want the OSD show me "POWERDIVX ON" few seconds.
I press the button again, the "winamp" group is enable and I want the OSD display "WINAMP ON"
you understand (I've bad english I'm a poor french :smile:
How to do that trick ? :smile:

thx :wink:

[Ninipc]

I found alone :grin:

[Ninipc]

Yes it's correct :smile:
and I've replaced OSD by some nice bitmap :smile:

[maysken]

The way that I conquered this issue was to create another command right below the "on" command with the same state values as the "on" command, and after selecting the new command and naming it something like "announce divx on", with the new command selected, go to the girder tab and select 'question'. Now just type the announcement that you want to see on the screen in the box labled 'Icon/Device' and hit apply and you are done. Incase you meant that you also didn't know how to setup the control to enable one group and disable others, take a look at the help file with the program....it's one of the few things covered there.