How to copy learned codes?

[Ron]

I'm not sure i understand this, because Girder saves all the codes in the .gir file. So you only need to save that. What hardware are you using ?

-Ron

[Ron]

Yeah those settings are stored in the registry but they don't influence the IRcodes,.. at least they should not. So i have no clue what is happening. Maybe you could manually check if the codes that are being sent are still the same as before (open with a text editor or something if the code is longer then the led display)

[jediperry]

You didn't just forget to initialize the hardware or tick the Auto Enable device or something like that did you? These settings are stored somewhere else if I remember rightly.

Mike

[Wykat]

Hi,

I'm planning to make a fresh installation (too much garbage in the present partition). When I copy however the whole Girder directoy, I still have to learn all codes again. Is there a way to avoid this?

Wykat

[Wykat]

response from the master himself :wink: I was hoping the info would be in the .GIR files. I copied the whole Girder directory to a new partition and started Girder again, but it didn't recognize any of the earlier commands.
I had to reinsert the groups, but even this didn't help.

Maybe I did something wrong. Will try again tomorrow.

I'm using the UIRT interface. Everything is still working fine on the 'old' partition. (never though a working system :wink:

Ron, I can only say I'm really happy with this software. Hope I can resolve my question.

rgrds,
Wykat