Specific Channel in dscaler?

[sticks123]

The easiest way I found was to download DScaler 3.0.9 and then auto scan all the channels. I then edited the program.txt file in notepad and made it so that it included all channels. Once you do this save the file and then go back into DScaler. For the channels that you do not wish to have just uncheck Active and then it will no longer be active. The reason why I say to download 3.0.9 is because the older versions do not store the channel right because it does not read the channel numbner like the newer versions. Just then program the numbers as the number you want and use the following for the channel up and down:

CH + = Command Tab - Command - WParam 65802
CH - = Command Tab - Command - WParam 65803
Full Screen = Command Tab - Command - WParam 480

Hope that Helps

[bcmagog]

First off, what an excellent program Girder is! I am using it in combination with IRMAN and eventually the pronto to control dscaler, but my specific question is:

In dscaler, there is a command for channel up, channel down, and previous channel via shortcut keys.

Is there any way to jump to a particular channel? Currently, I have girder programmed to do the following actions via a multigroup (e.g. USA network):

right mouse click (this pulls up the menu)
C (this highlights the "channel" selection)
U (this highlights "USA")
Return (ends the multigroup by going to the channel)


However, this really doesn't work on the upper channels because when the "c" is engaged, it pulls to the middle of the menu.

Is there a better way?