JustinM
March 30th, 2004, 07:12 PM
I'm currently using Girder to control SageTV. I'm using the Hauppauge Plugin found on Girders Plugin Page along with a .GML that uses SendMessages to control SageTV without SageTV requiring focus.
This way I can run Sage through my PVR-350 Hardware Out & still use my computer.
I can get all the commands working I need except 2: Page Up & Page Down.
Is there anyone here experienced enough with Girder or who can figure out how to send the commands for Page Up & down to Sage without it requiring focus?
As of now, I have Girder bringing Sage into focus & then sending F5 (Page Down) or F6 (Page Up). This is not really ideal.
Ideally it'd be through the same SendMessage commands that are currently being used, but I'd accept another way too.
Thanx
This way I can run Sage through my PVR-350 Hardware Out & still use my computer.
I can get all the commands working I need except 2: Page Up & Page Down.
Is there anyone here experienced enough with Girder or who can figure out how to send the commands for Page Up & down to Sage without it requiring focus?
As of now, I have Girder bringing Sage into focus & then sending F5 (Page Down) or F6 (Page Up). This is not really ideal.
Ideally it'd be through the same SendMessage commands that are currently being used, but I'd accept another way too.
Thanx