Girder stop receiving signal

[Dante]

Girder stop receiving signal after few button press.Does anyone know why ?
I must restart computer if i want it to work again.
Remote control is RealMagic Remote Control and i'm using Win98. I tried it with my second computer under WinXP and it works fine.

<font size=-1>[ This Message was edited by: Dante on 2002-01-16 14:00 ]</font>

[Dante]

really strange problem :sad:
i really hope that developers solve this.

[john55]

I'm seeing this exact same problem.

I'm using an IRMan receiver, and the problem only happens now that I'm using my new Denon RC-603 remote control that came with my Denon AVR-2802 receiver.

Once I have pressed the Up/Down volume controls a few times on my remote, Girder stops acknowledging input from most buttons on my remote. If I press a button on a DIFFERENT remote, then Girder starts working again!!!! Very strange!

I can also just fix the problem by disabling and then reenabling my IR receiver in Girder, so I know that it is a software problem and not a hardware problem.