Sending Ctl 1 to G-Force

[Cocophone]

I'm trying to use girder to send Ctl 1, or Ctl 2, or Ctl 3 to the G-Force visualizer for JRiver Media Center. I need to use the numbers above the letter keys.

I tried setting up commands in girder checking the ctl box and putting 1, 2 or 3 in the sentence box and tried checking the alt proc. box too but nothing is working.

Thanks for any help.

[jtgrunden]

I have the same question. I am trying to control dscaler using hotkeys which there are quite a few. The numbers on the keypad will not work, it has to be the ones above the letter keys.
With so may programs using hotkeys I'm hoping there is an easy way to send these multiple key sequences from girder. I have also tried using the keyboard commands to send Alt+Return which is in the drop down list and it was very unstable, the Alt key part of the command would only make it about half the time so it would execute the command for Return.

Any input is much appreciated.

JT

[Mysticeti]

I'd like to get Girder / USB-UIRT to send G-Force a "T" keystroke when I press a button on my remote but so far I haven't had any luck. It sounds like I'm not the only one.

BTW, "T" brings up track info when G-Force is in full screen mode.

[Jlee]

I'd like to get Girder / USB-UIRT to send G-Force a "T" keystroke when I press a button on my remote but so far I haven't had any luck. It sounds like I'm not the only one.

BTW, "T" brings up track info when G-Force is in full screen mode.
I just have it set to target 't' at the forground task and it works fine.

[Mysticeti]

Hey Thanks! That worked swimingly!