Two ir-codes for one command??

[Ron]

Use a 'goto' action.

-Ron

[bjoern]

Hi everyone,

I have a remote control (Loewe 201) sending two alternating codes for each button (no repeat code). Is it possible to teach (or configure by other means) Girder two IR-codes for a single command?

If not, what alternatives (other than just creating every command twice) would there be?

[bjoern]

working perfectly, thank you!

[hackNperl]

Im having the same problem accept a single button on my remote sends allot of different codes. I need to figure out how to let girder learn all the codes if possible or another solution. I dont understand what you mean to use a goto event.

[gmlegarf]

He means first create the command you want to carry out. Learn the code 1 for it. Create another command and use the goto girder action to point it to the original command (the one you want to carry out, as above), the code you learn for this one should be code 2 from your ir device.

Hope this claifies matters,

Regards,

Gaz.