How does girder get out of the learning mode

[robflying]

Girder is reciving commands now, I've depressed all of my remote buttons while in the learning mode, cancell learn then girder says awating ir code before this I save all settings, but nothing ir reverts back to the learning mode its like its in a loop. The led does change color from green to yellow, but Im not able to control my TT2 program. What are the settings in order? I must be overlooking something!

[Todd Reed]

What IR interface are you using? Is the plug-in loaded?
(See page 7 and 16 of the manual)
(Download manual and print for reference!)

Are you selecting the IR device on the Event pull down next to the learn button? Is it enabled (check box)?
(See page 10)

Do you see an Event? And a 12 digit IR code?
(See page 12)

If you got this far, do you see an Eventstring under the desired command? If so, when activated, the desired command should be selected and you should see it jump to that command.
(See page 15)

Lastly, have you set up any commands? Or is there a Theatertek group? If so, explain this in detail.
EG:
The WinDVD command for "play" is:
- Wparam = 99973
- Lparam = 0

Maybe review the WinDVD group for examples.

Regards,