no library view on netremote + jrmc 10

[richard.e.morton]

Hi everyone,

Thanks for reading my post!

I am struggling a little; I am a relative newbie to this. I have jrmc being controlled through mb from an Axim x5 (i think). All the control of jrmc works fine except the library view which displays a blank page. there is no root defined , lthough i have tried '\'. I have also got netremote to use the webserver built into jrmc 10, but same fault.

suggestions welcome.

thanks in advance

Rich

[Ben S]

Hi Rich - Can you try installing the Windows version and see if you get the same thing?

Also, what version of JRMC?

[richard.e.morton]

Hi,

Just so you know I am running JRMC 10.0.173 and netremote 1.0.037

The windows version is already installed and it works fine... any ideas?

any ideas?

Rich

[Jlee]

Check plugin properties and make sure you only have one instance of the media bridge plug in.

Also check in JRMC option> start up and ensure 'run remote server on port...' is turned off.

[richard.e.morton]

Hi,

Thanks for the fast reply.

I did have just one instance. I have just upgraded the ppc to the latest netremote/media bridge - also installed girder 4 and the designer. (basically a complete install) and now it works fine.

Thanks for everyones help

Rich

[Ben S]

Awesome. Thanks!