Binary registry data is accessed using a table.
To write a set of binary data to the registry, break it into BYTES (8-bit values) in a table and set the n index to the number of valid bytes. Like this:
Then use the standard write routine on a created registry object. Like this:
array = 20
array = 16
array = 78
array = 196
array["n"] = 4
To read a set of binary registry data, use the standard read routine on an opened registry object. Like this:
If error is 0, array is a table with the data in it and array["n"] is the number of valid entries (one byte each).
array, error = RegObj.Read("MyVariable")