Results 1 to 3 of 3

Thread: Girder V3.0.24 Pre 7 bug (using UIRT)?

  1. October 13th, 2002, 03:55 PM #1
    Flipper
    Flipper is offline Junior Member Newbie
    Join Date
    Dec 2001
    Location
    Itegem, Belgium
    Posts
    7

    Default

    Hello,

    Yesterday I received the components to build the UIRT, so after a few exciting hours in the workshop I could at last try everything out.

    Everything works perfect, but when I close Girder with the UIRT still enabled, I get a Windows error, leaving my COM port open, so I have to reboot in order to use the program again. Is this a bug in Girder or the combination with UIRT ? If the input devices are disabled before closing Girder, this error dus not occur. I use Danijels latest plugin for Girder.

    BTW, the only way I could program the PIC (20MHz) was using Danijels program and HEX file for the 10MHz pic. I built the original design, without the caps.

    Greetings,
    Filip
    Reply With Quote Reply With Quote
  2. October 13th, 2002, 03:55 PM #2
    Ron's Avatar
    Ron
    Ron is offline Senior Member Promixis Team
    Join Date
    Jan 2000
    Location
    Jupiter, FL
    Posts
    11,399

    Default

    Is this bug unique to pre 7 or to all versions ?
    Reply With Quote Reply With Quote
  3. October 13th, 2002, 03:55 PM #3
    Flipper
    Flipper is offline Junior Member Newbie
    Join Date
    Dec 2001
    Location
    Itegem, Belgium
    Posts
    7

    Default

    It applies to all versions apparently. I installed them all and got the same error.

    Strange. Am I the only one ?
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules