Install changed for latest version?

[mikeythemikey]

I can install 1.0.9.0 without issue on my simpad, yet the latest release doesnt not install.. has anything changed?

[mikeythemikey]

no one else having this problem then.. must be me.

[Ben S]

Hi Mikey - are you saying it doesn't install, or won't run after install?

[mikeythemikey]

Hi, it doesnt install. It runs through to the end of the install on the PC, says to look at the pda for further steps and it very quickly flashes something. There is nothing installed.

If I do the same routine with the October release, it installs on the PC, then when I look at the simpad screen you can watch it install..

[heysurreal]

Same problem here. Version from early December won't install on Simpad. Haven't tried latest version. Currently using a version from November (don't have Simpad with me so I can't say which version number I am using...sorry!)

Cheers

Mark

[mikeythemikey]

bump

[Ginsonic]

Got the same problem with NetRemote IR 1.0.16.0. Installations seems OK, but nothing happens on the Simpad (no files, no icons).

Support team please help !!!

By the way, where can I download the old installable version (can only see newest one on download site) ?

[Ginsonic]

Still no answer. Neither here nor via email. I bought this software ! Iit is no freeware, so why nobody cares about ???

[talm]

Ginsonic,

Did you try to download the CAB version and run it from the Simpad?

I had the same problem with the latest release and used one of the older ones and then ran the latest release and it went fine.

One thing I got to say about NR is that we have a great community here and everyone is helping each other.

Tal

[Ginsonic]

Hi Tal,

Sorry for my impatience, but I was burning to use this software on my Simpad ! It was not my purpose to attack someone here in this forum. Ben has answered me meanwhile, and I am sure, that a solution will be found. I will try to use the cabfile now.

Thanks again and best regards !
Gin