PDA

View Full Version : x10 examples



yonu
February 3rd, 2008, 12:38 AM
would anyone happen to have a gml file they would not mind sharing I need an example to go by to start configuring for my x10 setup. Basically say I have to motion sensor I want to require them both to be in a on state before girder will turn on the module

any help would be great
thanks,
yonu

yonu
February 11th, 2008, 09:11 PM
would someone mind helping me out I am trying to get the hang of this however I am not exactly sure when to begin the most complicated thing I can think of I am attempting to make girder do is watch 2 motion sensor and if 1 or the other detects motion to keep the light or whatever on then if nither of them detect motion for x amount of time to turn it off? any help would be great if someone could simply help me get started it would be great.

Thanks,
yonu

yonu
February 12th, 2008, 09:43 AM
come on now I know there are lots of people using girder to control there home automation systems

yonu
February 12th, 2008, 09:30 PM
well since I can't seem to get any help I suppose I will look into using other software and other solutions Girder seemed like it would do the trick but oh well.

Thanks,
yonu