View Full Version : Girder in carPC application

February 12th, 2008, 08:12 AM
Hi there

I'm not even a newby not having purchased Girder yet. I'm writing to determine if Girder will meet my requirements:

I've installed a programmable engine management system (ECU) in my car with carPC and I'm using a "frogpad" keyboard (due to its small size). However, the application that interfaces with the ECU requires complicated keystrokes for tuning the engine like ctrl-shift-uparrow, alt-l etc. With the frogpad these keystrokes become even more complicated.

1) Can I use Girder to translate a single keystroke like "a" to eg ctrl-shft-uparrow and "b" to ctrl-shft-downarrow etc?
2) Can I use girder itself to switch this translation on and off using eg, "1" and "0".


February 12th, 2008, 04:15 PM
That should be easy, yes.