PDA

View Full Version : Invalid Char



socket
July 4th, 2012, 09:04 AM
Hi, need some help in identifying the cause of the error message
invalid control char near
`char(0)'
when loading ccf into NR on my Pda.
It all works Ok in the Designer. The error first occured after putting a slider control into the mix, after testing with a minimal ccf adding the slider control will cause the error.Also discovered that just saving a good ccf in NRdesigner using save-as will also cause the error also the slider variablewatch code does not function.
Checked forum answers for this but cannot find the cause in this case.
Please advise remedy, thanks.
Have attached relevant test files, lua are same.

NR 2.076
NRD 1.1.042
The slider

socket
July 29th, 2012, 02:39 PM
Hi, Still cannot get this software to function properly, programs freezing when Axim51v resumes from standby so will wast no more time on it, seems this has more bugs than an un-buried corps.