PDA

View Full Version : knowledge of ir remote codes



mbechaalani
December 29th, 2012, 08:37 PM
Hello,

After installing girder 3.2, I placed the igorplug.dll file in the plugins folder in order to set read from the ir receiver connected to the rs232 port. I followed the circuit schematics found in the settings of the plugin. When the application shows that it is ready to receive ir signal no data in hex is shown on the red lcd panel although when I go back to file-->settings-->general--> "messages are recorded(the number of times I pressed a button) but 0 messages dropped" message is shown. What is the problem? and if it is solved how can I read the header ,one,zero timing information along with the custom and data codes information (in hex)?

Thank you a lot.
Michel Bechaalani.