PDA

View Full Version : PIR-1 Learning Remote IR codes Issue



metalheaddad01
May 11th, 2013, 10:09 PM
First I'd like to apologize if I am posting in the wrong area.

I had an IR-Man working for years that was programmed into Girder and when I added an event and clicked "Learn" it would add the IR code.

I have purchased the PIR-1 and when I perform the same procedure I see the code display 2 or 3 different codes really quickly before it "Learns" for some reason. Also, when I'm not "Learning" codes and just have Girder 5 open and I press any button on my remote and hold it I see the code at the bottom and it looks like it's scrolling through thousands of codes really really fast. It's like each button has a rolling code or something but it never did that with the IR-Man. The only thing that's changed is that I went from the IR-Man to the PIR-1.

Has anyone else had this issue?

Please help!

Thanks!

metalheaddad01
May 13th, 2013, 12:05 AM
Nevermind...Downloaded the latest drivers and extracted them into the Girder5 directory and that solved the problem.

I'm leaving this post up for anyone else who runs across this issue.