View Full Version : Different captured IR code, same buttons on remote control

June 15th, 2003, 01:11 AM
Everytime i press the same button on the remote control girder reports a different captured IR code.
Is this normal? Or is there something wrong? Maybe some filter needed?

I use the UIRT2 and the PIC has V1.7 installed with the new UIRT plugin and Girder 3.2

Any info would be appreciated.


June 15th, 2003, 08:44 PM
I just found the little info about Noise filters. I only added a 100nF cap to the IR receiver without the ferrite and it works perfect now.

Always the same code appears with the same button now. :) :) :)