PDA

View Full Version : UIRT2 Recievs but dont transmits.



peegee
February 26th, 2004, 11:34 AM
Hi all!

Ive succefully assambeld the uirt2 and everything is working fine on some equipment.

Success:
Learn and transmit from and to an old Finlux TV.

Learn commands from my Force D-Master 1144T box remote controll.

Failure:
Transmit learned commands to my Force box.


Did some research and come up almost emty handed.
It wouldnt be the 40kHz+ limitation right, since i can learn codes just fine.

Im using the UIRT_10MHZ_1_8.HEX.

Everything in the girderplugin is set by its defualts.

What am I doing wrong?

Thanks in advance.

EDIT: Just o couple of small changes.

peegee
February 28th, 2004, 07:13 AM
After some more research here at the forum it seems that some remotes must be held very very close to the reciever.

Im dont think thats my problem though, because i can learn events just fine in girder with that troubleremote and they executes properly.

Strange right?

Btw..i cant find spec:s on my Force 1144T irfreq. Does someone know how to find out or were to look?

peegee
February 29th, 2004, 07:56 AM
Ok im really stuck now. :(

I did the "RXD, TXD, GND"-only cable with the same results.

Flawless TX and RX to old Finlux TV, and a Yamaha RXV795 reciever.

However I couldnt get the RAW-mode learned codes to work with the Yamaha, but normal learning and importing works fine.

The strange thing is that in Girder i can learn events and execute them with any remote, but not in the UIRT plugin. (The latest)

Did write an email to Force.tv, trying to get a hold of their discrete IR-codes for the FOrce 1144T. I guess they are my last hope.

The IR-debug mode, how is that useful btw?