View Full Version : Hairstyle Code Reference

May 6th, 2003, 08:25 PM
With the new Hairstyle interface that has been released with Media Center 9 are there direct codes that I can use to directly control this screen without needing to connect to Girder? I only need codes for UP, DOWN, LEFT, RIGHT, ENTER, and TAB. I have noticed with 99rc2 and 99rc3 that there are more codes that allow direct control of Media Center not needing to involve Girder (either the new commands in braces {} or hex code for Tonto)

Thanks for the help...


Ben S
May 8th, 2003, 09:25 PM
Hi Kevin.

I'll take a look.

May 31st, 2003, 06:30 PM
Hi Kevin.

I'll take a look.

Any progress on this?

June 2nd, 2003, 02:49 PM
Hairstyle is being over-hauled now and the navigation will be simpler in a build sometime this week.

Same with remote control. What was a plug-in will now be inside MC. Setup (including learning) will be in options/remote control. No need for Girder. Direct support for IR receivers.

Ben S
June 3rd, 2003, 06:46 PM
No progress yet. But since I'm depending on the new MC for RC5, I'll wait until it's out and see what I can do.