Results 1 to 3 of 3

Thread: "Translating" an IR-command

  1. #1
    Join Date
    Oct 2006
    Posts
    4

    Default "Translating" an IR-command

    Is it possible to send an IR-command to girder and this command gets converted into an ir-command that's sent by an MCE-Remote?

    For example I press "1" at my remote that has the IR-command "001000001110" (random number). Then Girder converts this into the IR command that's sent when pressig "1" on a MCE-remote with an MCE IR-receiver.

    I'm asking this because my HTPC has an IRTrans Device inside and I don't want to use the original MCE IR-Receiver. But some buttons aren't recognized correct with IRtrans so I wonder if Girder can "correct" them for me?

    Can I do that at all? If yes, do I need plugins for that?
    I hope you know what I actually mean

  2. #2
    Join Date
    Dec 2001
    Posts
    11,560

    Default

    Hi, need a little more detail...

    Do you need to send these command back out again?

    ie MCE Remote -> IRTRans -> MCE Blaster?

  3. #3
    Join Date
    Oct 2006
    Posts
    4

    Default

    Hi!

    No, I don't want to send them back out. I want to use a different Remote to control VMC, but I don't want to assign the buttons on the remote to keyboard, I want to assign them to the IR command that would be sent if I press the same button on the original remote control.
    I hope I made it clear what I want.

    Thanks for you help in advance

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •