Results 1 to 3 of 3

Thread: Strange prob?

  1. #1
    Join Date
    Jun 2006
    Posts
    181

    Default Strange prob?

    OK,
    I have girder set up on and xp machine running no problem, connected to my amp, sweet. I can control it from NR, but only from my laptop, which runs vista. Designer is also on the laptop (My devepoment machine). When I transfer the ccf over to another machine it's like the commands get lost and don't work. Any Ideas. I have a display in NR which shows the status of the receiver and that works. Strange eh?

  2. #2
    Join Date
    May 2004
    Location
    Cardigan, UK
    Posts
    9,278

    Default

    Check that both NR instances are using the same Girder plugin instance id for the same machine. There are a couple of possible scenarios here -

    1. You've used -1 as the instance id for the commands, but the default instance of the Girder plugin is different on the two NR installs
    2. You've used e.g. -2101 as the instance id in the commands, but NR on the other machine is using -2001 as the instance id.

    There are probably some more possibilities, but those seem the most likely.
    --Rob

  3. #3
    Join Date
    Jun 2006
    Posts
    181

    Default

    Thanks, that was the problem. I guess it's easy to overlook at 2:00am. Only spare time I have these days!!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •