Results 1 to 1 of 1

Thread: 1-Wire Device Wrapper

  1. #1
    Join Date
    May 2004
    Dallas, TX

    Default 1-Wire Device Wrapper

    The files below can be used to add 1-Wire devices to the Girder Device Manager.

    A couple of notes:
    1. This does not replace the OneWire.dll required to acquire the status of the devices
    2. Prior to install remove any OneWireDM files. If I remember correctly there is one located in each of the following folders; plugins\ui, plugins\treescript and luascript\DeviceManager\providers.
    3. Right now this only supports the temp sensors. Anyone using other sensors, if you can provide me with some debug of those sensors, I will include them as well.

    I think that is it. Once installed, the component will poll the OneWire.dll file for a list of installed devices. In Component Manager->Misc.->1-Wire Network you can view the list of devices and set the polling rate.

    Any questions or problems, let me know.

    Edit: Unzip the files to the Girder install folder.
    Attached Files Attached Files
    Last edited by harleydude; February 12th, 2009 at 01:17 PM.

    Girder 6.0 - Elk M1 Gold - JRMC 11.1 w/ M-Audio Delta 410 - NetRemote - BlueIris DVR
    Girder 6 Plugins - Elk M1/EZ8, Pushover Connector and more on the way.

    Visit My Showcase

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts