When I register for events, it always has an empty table for the addresses. If I remove the com port from the list in the plugin configuration, then send some events, and then put in the com port for the plugin again, all of the stored events in the cm11a are output properly, including the address table. But any future events that occur after configuring the com port for the cm11a do not include any values in the address table. Also, only the events that included the address table generate girder events. It seems the plugin works for the initial reception of data, but then somehow ends up in a state where future events do not show all the correct data. I'm happy to provide any information required to resolve this problem.